 |
Products [close bar]
Untitled Document
|
 |
| Load / Charge controller |
 |
| Xantrex C40 & C60 Charge Controllers
For use in Battery-Based systems, these rugged charge controllers offer protection against overcharging when used with our wind turbines. The Xantrex C60 is capable of handling charging currents of 60A, and is suitable for use with battery banks of 12V and 24V only. The C40 can handle charging currents of up to 40A, and is suitable for use in 48V battery charging applications which use our turbines.
In order to use either of these controllers with your FE Turbine and Battery Bank, you will require a suitable dump load for connection to the C40 or C60. These dump loads are shown below, and can be bought separately if required.
The following number of dump loads are required with each of the following battery voltages.
For 12V systems use only the C60 and 2 Dump Loads (in parallel)
For 24V systems use only the C60 and 1 Dump Load
For 48V systems use only a C40 and 2 Dump Loads (in series)
|
| |
More |
|
